CLW GROUP's Dongfeng chicken transport truck exported to Tanzania. The body is made of glass steel plate inside and outside, 8cm insulation board in the middle, aluminum checkered plate, 2 shutters on the front panel of the body, 3 shutters on both sides of the body (with small doors can be Open), two electronic fans (with sliding doors) on the back door of the box, two skylights on the top of the box, three electronic fans on each side of the skylight, two ventilation ducts on the bottom plate, and two outlets on each side of the box At the door, Hanxue L-Z20 refrigeration unit is installed.
The truck-mounted crane is a kind of equipment that realizes the lifting, turning and hoisting of goods through a hydraulic lifting and telescopic system It is usually assembled on a truck The truck crane brands produced by CLW Group are divided into: Dongfeng, Jiefang, Foton, Jiangling, Jianghuai, Liuqi, etc; according to the boom, it can be divided into: 2 boom or 3 boom, 4 boom or multiple boom; The crane types are divided into: straight arm type and folding arm type crane The tonnage is complete, and users can choose and buy on demand,what licence do you need to drive an ambulance uk.
The truck-mounted crane is in high-intensity and dangerous operations for a long time, and it is necessary to pay attention to the normal maintenance of the vehicle to avoid accidents. Therefore, the editor of CLW Group summarizes the following points for your reference. 1. Check whether the power output power take-off of the chassis is operating normally, whether the fixing bolts of the drive shaft are loose, whether the operation is balanced, whether the hydraulic oil pump has abnormal noise or oil leakage. 2. The telescopic boom is driven by a hydraulic cylinder or cylinders to drive several sets of cables to realize the extension and contraction of the boom. To see if the cables are loose, and there is no tension, the pre-tensioning needs to be adjusted.
Live to be old, and learn to be old This sentence is also very appropriate for the members of the Zoomlion team Especially in the ever-changing technological era, there are too many technological inventions and technological innovations coming out every year The continuous learning of the team is the best way to maintain the vitality of the enterprise In order to keep up with the pace of market changes, this is what we must always do Things At the same time, CLW Group attaches great importance to improving the personal abilities of its employees in order to enhance the overall strength of the entire team,what licence do you need to drive an ambulance uk.
The above is about the part of the daily maintenance and maintenance of the compression garbage truck shared by CLW Group: 1. The oil seal on the drive shaft is damaged. Replace the oil seal. The fault is mostly caused by dirty oil. 2. The control lever of the compression garbage truck is connected incorrectly or stuck. re-install. 3. The valve body connecting bolts are too loose. Tighten the bolts to achieve the torque required by the manufacturer. Replace the O-ring seal between the valve bodies. If the O-ring seal is damaged by dirt, clean the hydraulic system and find out the cause of the contamination. The cylinder barrel is damaged. Replace the cylinder and find out the cause of damage. 4. The piston rod seal is leaking oil. Replace the seal to find out the cause of wear. Both internal and external dirt may cause damage to the seal, which should be repaired in time.
