What are the wheel loads of a fire truck,The 4.5-ton electric watering truck truck produced by CLW GROUP's production plant has been highly praised by Guangdong customers. The announced volume of the truck is 4.04 square meters, with a rated load of 3850kg; a full-load climbing degree of 25%, a charging time of 1.5h, and a working voltage of 512V. Driving range: 320 (km) (full load constant velocity method) Battery capacity: 158.7 (kwh), battery cell type: lithium iron phosphate. watering truck width: ≥16 (m), water cannon range: ≥37 (m), pump head: 50 (m) pump flow: 40 (m³/h).
The filling port of the lpg tanker truck produced by CLW GROUP is produced according to European standards, with built-in breathing and emergency exhaust functions, and the folding guardrail can be raised and lowered, which is convenient to use. The down-loading system includes oil unloading valve, oil and gas recovery, subsea valve and other devices. The subsea valve can automatically disconnect the pipeline in an emergency to prevent leakage. Oil and gas recovery can effectively prevent the leakage of oil and gas, and the oil unloading valve can avoid the diffusion of oil and gas. In addition, the tanker is also equipped with a fire extinguisher, and a static electricity conducting device at the rear to prevent accidents caused by static electricity during loading, unloading or transportation.
What aspects should be paid attention to when using the "CLW"" Dongfeng kitchen garbage truck? 1. It is strictly forbidden to put construction waste into the kitchen garbage truck to avoid damage to the parts. 2. If the hydraulic system of the kitchen garbage truck is operating abnormally, Work should be stopped immediately, analyze the cause, eliminate the fault, and do not force pressure to work. 3. Whether it is engaging or disengaging the power take-off, you must step on the clutch pedal; the power take-off and multi-way reversing valve are in working condition At the time, the garbage must not enter the driving state. 4. The pressure regulating device of the hydraulic system is the pressure regulating bolt on the multi-way reversing valve. After the pressure is adjusted and locked, the bolt should not be arbitrarily adjusted during use.
What are the wheel loads of a fire truck,Cheng Aluo has a legendary experience in the special-purpose vehicle industry. He joined the work in November 2003 and has been the chairman and general manager of CLW Group since 2004. Under his leadership, the company covers an area of only 56 acres and has 80 employees. A small enterprise with an annual output of less than 900 vehicles and an output value of 8 million yuan. After several years of development, it now covers an area of 380 acres and a building area of 98,000 square meters. It has 3 branch factories, Chengli Vocational School and company functions. A group company with more than 20 units in the department.
What to do if the surface of the sprinkler is rusty? The editor of CLW Group recommends the following: There are two types of rust on the surface of the sprinkler. One is the rust on the paint surface. Normally, such rust cannot be dealt with by yourself. You must get an outside car specializing in sandpaper to help you remove it. Rust and then touch up the paint. If the rust is not very serious, you can first use very fine water sandpaper dipped in water to lightly polish the rust spots, but avoid random grinding without direction, and polish in the same direction. After it is completely wiped off, apply a layer of primer.
