The 4.5-ton electric watering truck truck produced by CLW GROUP's production plant has been highly praised by Guangdong customers. The announced volume of the truck is 4.04 square meters, with a rated load of 3850kg; a full-load climbing degree of 25%, a charging time of 1.5h, and a working voltage of 512V. Driving range: 320 (km) (full load constant velocity method) Battery capacity: 158.7 (kwh), battery cell type: lithium iron phosphate. watering truck width: ≥16 (m), water cannon range: ≥37 (m), pump head: 50 (m) pump flow: 40 (m³/h).
The mixer truck is a special truck used to transport concrete for construction. During the transportation, the mixer drum will always be kept rotating to ensure that the concrete does not condense. The Dongfeng Huashen mixer truck produced by our company adopts original pure imported reducer, with a service life of 5-8 years, and all hydraulic systems adopt internationally renowned hydraulic systems, such as German Rexroth, American Eaton, American Sao, and Italian PMP hydraulic system, and tank operation More stable, faster discharge speed, low residual rate!what does gsw mean from ambulance to er
Today, the editor of CLW Group introduces the maintenance knowledge of sewage suction truck 1 Start the engine of the sewage suction truck at least once a month, run it at idle speed for 4-5 minutes, and check the operation of the engine If there is any abnormality, it needs to be adjusted and repaired in time In addition, always check the battery The electrolyte level of the battery must be 10-15mm higher than the electrode plate If it is insufficient, add distilled water in time, keep sufficient power, and charge the battery if necessary 2 The gasoline tank should be tightly sealed and the temperature should not be too high It is best not to store gasoline for too long,what does gsw mean from ambulance to er.
CLW Group has been in the special automobile industry for more than 10 years. Today’s achievements are inseparable from the unswerving execution spirit of the company’s management team, the hard work of all the company’s employees, and the entrepreneurship of the company’s senior team. Passion. In the past 10 years, every step that CLW Group has taken has not been easy, but fortunately, with the strategic vision of Chairman Cheng Aluo and the technical strength of Director Ni, every step is so solid and steady.
How to solve the common problem of non-absorption of sprinkler pumps? CLW Group will answer for you. The first step is to check whether the switch is turned on. The second step is to check the filter. When the sprinkler pump is not working well, check whether there is debris blocking the water inlet on the front filter of the suction pipe, and then check whether the water inlet pipe is sealed step by step, and check whether there is an air leakage failure. The third step is to check the vacuum. The water diversion height of the water pump used by ordinary sprinklers should be less than 5 meters, and then check whether the oil seal of the water pump of the sprinkler is damaged. Leakage of the pump shaft affects its vacuum, and the seal should be replaced. The fourth step is to check the power take-off. Check whether the power take-off of the sprinkler is working. The separation of the power take-off from the drive shaft will cause the water pump to fail to work.
