CLW GROUP's Dongfeng chicken transport truck exported to Tanzania. The body is made of glass steel plate inside and outside, 8cm insulation board in the middle, aluminum checkered plate, 2 shutters on the front panel of the body, 3 shutters on both sides of the body (with small doors can be Open), two electronic fans (with sliding doors) on the back door of the box, two skylights on the top of the box, three electronic fans on each side of the skylight, two ventilation ducts on the bottom plate, and two outlets on each side of the box At the door, Hanxue L-Z20 refrigeration unit is installed.
The folding boom aerial work truck produced by our company has beautiful appearance, powerful functions and high safety factor. It has a number of advanced operation safety functions to ensure the safety of operators. The products are widely used in electricity, street lights, municipalities, gardens, Communication, airport, shipbuilding (repair), transportation, photography and other high-altitude operations. It is an ideal vehicle for high-altitude operations such as municipal management, power supply maintenance, traffic management and other departments for power maintenance and road sign installation.
Fire trucks must be cleaned after each use, so as to extend the service life of fire trucks What should we pay attention to when cleaning? 1 After using the CLW Group fire truck water pump, turn on all the remaining water switches on the pump to release the remaining water in the pump After the remaining water is discharged, turn off all the switches The purpose of this is to prevent freezing in winter or use it next time 2 After the pump has used seawater, polluted water, corrosive water flow and foam mixture, use clean water to transport for more than 1 minute in order to clean the residual liquid in the pump 3 Regularly check the lubrication in the bearing, if it is lower than the oil level, it should be made up in time 4 After using the fire pump of the fire truck in winter, run the piston pump several times to drain the remaining water in the piston pump to prevent freezing and damage the pump to affect the next use,how does a truck mounted crane work.
In order to ensure that the CLW Group team is a high-quality team, all employees must pass strict interviews before entering the company The company first has a three-month application period Once the trial is successful, the benefits and benefits will be favorable In addition, the company has also established its own technical training school to continuously input fresh blood for the company At the same time, it has been maintaining in-depth exchanges and cooperation with major polytechnics, striving to master the most cutting-edge technology and industry information, and remain invincible,how does a truck mounted crane work.
What should I do if the clutch of the road sweeper is not completely separated and the clutch pedal cannot be returned after being depressed to the end? CLW Group reminds users to follow the steps below: 1. Connect the air pump to the gas pipe joint on the top of the liquid storage pile, and tighten the liquid storage tank cover. 2. Remove the protective cover on the exhaust valve of the working cylinder, install the exhaust hose, and insert the other end of the hose into the hydraulic oil collection container. 3. Use an inflator to pump air continuously, and at the same time loosen the exhaust valve of the working cylinder, use the pressure of the compressed air to force the oil pipe, the master cylinder, the oil in the working cylinder and the infiltrating air to be discharged together until the discharged oil When there are no air bubbles, tighten the exhaust valve.
