- Garbage Compactor Truck
- Side Load Garbage Truck
- Roll-off Garbage Truck
- Garbage Collection Truck
- Food Waste Garbage Truck
- Skip Garbage Truck
- Ambulance
- Mobile Clinic Vehicle
- Concrete Mixer Truck
- Truck-mounted Crane
- Refrigerated Truck
- Fire Engine
- Watering Truck
- Spraying Truck
- Street Sweeper
- Vacuum Truck
- Flatbed Transport Truck
- Aerial Work Platform Truck
- Tow Truck
- Dump Truck
- LPG Truck
- LPG Storage Tank
- LPG Semi-trailer
- LPG Filling Station
Garbage truck steering failure small tips
When you are driving a garbage truck to work, you find that the vehicle's power steering system has a small failure. After these small failures are sent to the repair station, the technicians will fix it two or three times, and some fees will be charged. The way to deal with it is very simple, you can solve it yourself. If you can master the method of handling minor faults of the power steering system, you can save time, worry and expense. So what are the small methods for the steering failure of the garbage truck? Let's learn together below:
- Use fine sandpaper to clean the paint and rust on the input shaft, then loosen the sealing nut of the lower stroke valve and the adjustment screw of the upper stroke valve for two turns; before unloading the valve body, mark the valve body and the shell to install it in place Remove the valve body bolts and remove the valve body; take out the valve sleeve in the valve body; take out the 2 bearing thrust washers and thrust bearing in the valve body; remove the rectangular oil seal of the valve body in the sealing groove of the valve body end face.
- Remove the steering gear. Clean the dirt on the surface of the assembly, especially the dirt around the nozzle. Drain the oil in the assembly and immediately plug the nozzle. Remove the connecting parts on the rocker shaft and the input shaft. Remove the steering gear from the bracket.
- Remove the small hexagon head bolts, tap the end face of the rocker shaft with a copper hammer or wooden hammer, slowly disassemble the side cover and rocker shaft assembly; unscrew the rocker shaft adjustment screw lock nut, and take out the side cover Gasket assembly; separate the side cover and the rocker shaft; take out the retaining ring, seal ring assembly, thrust washer, support pad, and plug. Replace the bearing and rocker shaft adjustment screw if necessary.
Do you understand the above methods? If you don’t understand, it is recommended that you spend some money to find a maintenance technician to help you deal with it, so that you are not afraid that the power steering system cannot be used normally due to poor handling. If you understand, remember to save this article and follow the above steps correctly to ensure the good steering system of the garbage truck and the normal operation of the vehicle.
- Chassis Brand:ISUZU
- Size:8165×2480×3500mm
- Price:Starting at$55000
- Chassis Brand:DONGFENG
- Size:8450×2500×3500mm
- Price:Starting at$70000
- Chassis Brand:DONGFENG
- Size:5990×2000×2380mm
- Price:Starting at$15000
- Chassis Brand:DONGFENG
- Size:6940×2130×2800mm
- Price:Starting at$25000